Watch Maintenance Guide: Fixing Common Problems Yourself

Understanding Common Watch Problems

Collectwatches – especially super clones that closely mimic luxury brands in appearance, internal mechanics, and materials – require careful handling. Their high level of craftsmanship makes them prone to damage if not maintained properly. Below we break down the typical issues and how to address them.

Step-by-Step Solutions for Frequent Issues

1. Watch Won’t Start

This is one of the most common complaints. It usually points to a battery problem.

Open the case back, remove the battery, and inspect for bulging or leakage.
If bulging, replace the battery immediately.
If you see white crystals on the battery surface, leakage has occurred. Clean the battery compartment and the copper contact posts with isopropyl alcohol before installing a new battery.

2. Deformed Case

Cases are typically stainless steel or alloy, offering some elasticity, but impacts can bend the case or misalign the dial.

Minor deformation: Use a case‑crimping tool or gently adjust the case knob (if applicable).
Major deformation: The case must be replaced. Ensure you purchase a compatible replacement from a trusted Collectparts supplier.

3. Cracked Watch Glass

Glass is the most fragile part – a sudden knock or drop can cause cracks.

Disassemble the watch carefully: remove the crown and stem, then take out the movement.
Remove the old glass by pressing from the inside outward (or use a crystal lift).
Press in a new glass of the correct diameter. Avoid excessive force to prevent cracking the new glass.

4. Movement Stalls or Stops

A dirty or defective movement can cause the watch to stop running.

Open the case back, remove the movement, and place it in a watch cleaning solution (or ultrasonic cleaner with watch‑grade fluid).
Clean all parts thoroughly, oil pivots where necessary, and reassemble.
If the problem persists, the movement may have mechanical wear – consider a replacement movement from the same clone factory.